Anatomy of a WurliTzer Theatre Pipe Organ
Installing the secondary pneumatics.
The row on the other side are already in place.
This must be close to the most awkward operation involved in a WurliTzer restoration.
There is little space between the top boarb and the pneumatic rail in which to work. I chose
to glue the pneumatic gaskets in place on the pneumatic rail before the top board was put in place.
The connecting wire needs to be attached to the pneumatic and doing that before glueing the pneumatic
in place enables much more movement to twist the pneumatic around and get the hook on the pneumatic
through the loop on the connecting wire. The hook can then be closed up to prevent it from slipping out.
Once everything is connected you just need to glue the pneumatic down. I applied the glue to the gaskets
because you then know exactly where it needs to go. The problem is the lack of space which does not make it
easy to get the glue in there, or see where it is going.
The photo was taken verically downwards, so the chest is actually sitting on its back, tilted slightly
so that the glue does not run off the gaskets too fast. Having the chest horizontal, near eye level,
would have been easier for the glueing phase but would make it more difficult to connect the wires.
It does not seem possible to connect all the wires and then glue them all because of the even greater
restriction in working space and switching from vertical to horizontal for each pneumatic would be
difficult so a compromise seemed to be the only practical choice.
Simple tools were used to hold things out of the way as much as possible. Clothes pegs to keep the
connecting wires out of the way until needed, and callipers helped hold the pneumatic closed while the
glue was applied.
It would be interesting to see how it was done in the factory.
Getting the chest apart was much easier. I just removed all the pneumatics from their rail and removed
them with the top board. Unfortunately two actions had been added previously and those pneumatics were
attached with PVA glue WITHOUT GASKETS! There was no way to seperate them from the board so the leather
was cut apart and only the top half was removed with the top board. The lower half of those pneumatics
were removed from the rail with a plane.