Anatomy of a WurliTzer Theatre Pipe Organ


The leather puched out ot the gasket for the bottom of the bottom board, which is covered by the valve cover board, is the right size to cut out the gaskets for the primary pneumatics!

The valve board gasket was punched with 7/8" holes, which leaves a minimal amount of leather between the holes at 1" spacing, and then the concentric punches at 3/4" and 1/4" cut out the pneumatic gaskets from the first waste.

Have not found a use for the 1/4" waste punchings yet!


This page brought to you by:
VintageHammond.Com - We Buy-Sell-Trade Vintage Hammond Organs and Roll or Kari Organ/Vending Machine Moving Dollies Order Roll or Kari Dollies Here